Tired of looking for your favorite pictures right frame size? Do not worry. Try to make your own! This is a good novice woodworking project. Here are a few steps to create a picture frame.
　　1 to determine the desired frame size. Remember to use the mat as a guide, not pictures, to determine the finished size.
　　2, select the frame molding construction site, or your frame wood molding. Frame molding, in framing shops, art shops and large craft stores. Builder of the molding and wood can be found in the local home improvement store.
　　3 measurement framework you choose the width of the material, this figure is multiplied by 8. Add to your desired length of each side frame measurements. Divided by 12 (most of the wood is sold by the foot) total inches. The amount of material procurement framework with an additional error in the case of cutting a few inches.
　　4 Use the handsaw cut into four, one for each frame of the side molding. Each side should measure the desired length plus twice the width of wood. This extra amount of mitered corners.
　　5 Use a miter box and handsaw to cut the end of each piece 45-degree angle. Allows the piece of wood firmly miter box and guide, so that it cuts at the correct angle.
　　6 frame parts Lecce to a flat work surface and arrange them so that they form a picture frame frame.
　　7 using wood glue and clamps to join the frame angle corner part. Application of wood glue along the cut edge of the piece together, in a corner of the pieces held in place inside the folder. Glue and crack down on all four corners.
　　8 rotating frame, so that the back up.
　　9 apply adhesive seam with a hammer along each corner of the two V nails. Pace one nail toward the inside edge to the outer edge of the frame, and others. Nails should rest on the seam and midpoint to open Part V should be noted that within the framework of the edge.
　　10 Remove the clip and allow the framework to dry overnight. Drying process is complete, polished or dyed any framework.
　　11 to the picture frame hanging system framework.